Learn QUICKSURFACE For SOLIDWORKS® now! We highly recommend watching them in the order they are listed.
Please note: You can use the sample files only for training purposes while learning QUICKSURFACE for SOLIDWORKS® . You cannot redistribute the files or use them for any other purposes.
Basic part (prismatic shapes) STL:
Download
Aerosol knob (free form surface) STL:
Download
*All video tutorials and STL files created and owned by www.mesh2surface.com. Better 3D Lab is the official reseller of Mesh2Surface and QUICKSURFACE products in Australia.
You need to have a valid SolidWorks® license installed before you can install the QUICKSURFACE add-in.
Exit SolidWorks® if it has been launched in Windows. Download the installation file of the QUICKSURFACE add-in. Double-click it to start the installation.
Follow the instructions until it gets installed and then launch your SolidWorks® software. Start with a new part or an existing part.
You should see a new QUICKSURFACE (or Mesh2Surface, as it shows here, for the older version) tab in your UI.
If you don't see this tab in the UI, please go to Tools > Add-Ins...
Make sure both boxes under Active Add-ins and Start Up for QUICKSURFACE (or Mesh2Surface) are ticked. Hit OK.
Right-click SolidWorks® module tabs region and click QUICKSURFACE (or Mesh2Surface) to enable it.
Click the License button below Settings.
A Licensing window will pop up. Copy your license key and paste it here.
Please note that even if you're just evaluating the QUICKSURFACE add-in, you still need a trial license key to activate the add-in. Please contact us at contact@better3dlab.com to obtain a trial license key.
After activating the QUICKSURFACE add-in, you need to restart SolidWorks® for it to take effect.
 |
